FLYWHEEL STEP: .850"
NEW LUK, FLYWHEEL STEP: .850"
SIZE: 12"
NEW LUK
SIZE" 12"
BEARING WITH CAST IRON CARRIER
SIZE: 12 7/8", INCLUDES: RING GEAR, FLYWHEEL ID 13.030"
142 TOOTH RING GEAR
(R97872 NEW AVAILABLE); THIS IS A 40 CM (2.4 CI) HYDRAULIC PUMP THIS PUMP HAS A 1 1/16" INLET PORT ON MOUNTING FLANGE LEFT SIDE , A 1 5/8" INLET PORT ON MOUNTING FLANGE RIGHT SIDE, A 1 1/16" PRESSURE PORT IN PUMP BODY ON RIGHT SIDE, A 7/8" COOLER RETURN PORT ON TOP AND A 3/8" DRAIN PORT ON BOTTOM. NOTE: IF YOUR APPLICATION DOES NOT HAVE A DRAIN LINE THE INSTALLATION OF J D PART AR39810 DRAIN LINE KIT IS REQUIRED THE INDICATED SIDES OF THE PUMP ARE AS SEEN FROM THE TRACTOR SEAT
THIS IS A 40 CM (2.4 CI) HYDRAULIC PUMP THIS PUMP HAS A 1 1/16" INLET PORT ON MOUNTING FLANGE LEFT SIDE , A 1 5/8" INLET PORT ON MOUNTING FLANGE RIGHT SIDE, A 1 1/16" PRESSURE PORT IN PUMP BODY ON RIGHT SIDE, A 7/8" COOLER RETURN PORT ON TOP AND A 3/8" DRAIN PORT ON BOTTOM. NOTE: IF YOUR APPLICATION DOES NOT HAVE A DRAIN LINE THE INSTALLATION OF J D PART AR39810 DRAIN LINE KIT IS REQUIRED THE INDICATED SIDES OF THE PUMP ARE AS SEEN FROM THE TRACTOR SEAT
1 1/16" MALE O-RING x 7/8" MALE JIC
45 DEGREE HYDRAULIC PUMP FITTING 1 1/16" MALE O-RING x 7/8" MALE JIC
USE WITH R79152, R79154 & R79156 SHAFTS
USE WITH R34348 SHAFT
USE WITH R34348 SHAFT AND USE WITH R45874B & R45874BR BUSHINGS Required: 2
USE WITH R79152, R79154 & R79156 SHAFTS USE WITH R80558B & R80558BR BUSHINGS Required: 2
USE WITH R79152, R79154, R79156 & R34348 SHAFTS Required: 2
INCLUDES: MOUNTING GASKET AND BACKPLATE GASKET, R932840 KIT AVAILABLE
FITS: R28438 INCLUDES: 2 GASKETS, SPRING SEAL AND BEARING
SEAL INSTALLER FOR THE INSTALLATION OF UNITIZED WATER PUMP SEALS
ONE PIECE TEFLON SEAL AND WEAR SLEEVE ASSEMBLY SUB FOR AT22965, AR92893, RE11036, RE17831, RE24959